J
Hi,
Please help regarding an RTD reading spikes when a pump turns ON. The RTD PT100 is transmitted to a Huber, and when a motor 2 meters distance to the RTD sensor starts, spikes comes up.
Tried so far:
- double check the RTD termination
- changed cable into shielded wire
After changing into a shielded cable, it gives lesser spikes reading. Previously, from 25C to 400C, but after changed of cable, it goes from 25C to 35C.
Any suggestions in this regard.
I appreciate it so much
Joe
Please help regarding an RTD reading spikes when a pump turns ON. The RTD PT100 is transmitted to a Huber, and when a motor 2 meters distance to the RTD sensor starts, spikes comes up.
Tried so far:
- double check the RTD termination
- changed cable into shielded wire
After changing into a shielded cable, it gives lesser spikes reading. Previously, from 25C to 400C, but after changed of cable, it goes from 25C to 35C.
Any suggestions in this regard.
I appreciate it so much
Joe