A
In one of our roll feeding cut to length application Masterdrive servo V1.6 & PLC CPU314IFM.
We have got 2 separate drive programs if we load first program then feedback is from internal motor encoder & 2nd is for external encoder. We want to put switch so that with single input this changeover should take place.
Like in ABB & Indramat drive there is only 1 input required for 2nd parameterset activation.
With PKW mechanism it is difficult to send 60 parameters from PLC to drive for changeover.
Whether it is possible by single input in drive?
Can anybody helpme out for this problem?
We have got 2 separate drive programs if we load first program then feedback is from internal motor encoder & 2nd is for external encoder. We want to put switch so that with single input this changeover should take place.
Like in ABB & Indramat drive there is only 1 input required for 2nd parameterset activation.
With PKW mechanism it is difficult to send 60 parameters from PLC to drive for changeover.
Whether it is possible by single input in drive?
Can anybody helpme out for this problem?
