Hello everyone,
Adding tables to P&IDs is not very common, but in my case, when needed, I add a table with the different characteristics of the elements of the P&ID. The things added to this table depends on the project, and I want to start following a standard/specification for these tables.
I believe I do no find information because it is not a general practise...but can someone comment on this, please?

Do you normally follow a spec when addying tables, and if so, which one...or do you normally add the table based on need?
Thank you very much in advance

 

Not sure, if I understand it correctly or not. In Drives, there are applications where we need to switch the Motors i.e., 1 Drive driving multiple motors but only 1 will be selected at any given point of time. In such case we do load different PID parameters corresponding to the motor selected.

Is your requirement something similar ? If not probably explain your requirement so that you will get a better answer.

 

Thanks for your reply.

In my case the P&ID belong to chemical delivery systems (Piping and Instrumentation Diagram), so sorry for the confusion with the PID you refer to (Proportional-Integral-Derivative).

 

Hello everyone,
Adding tables to P&IDs is not very common, but in my case, when needed, I add a table with the different characteristics of the elements of the P&ID. The things added to this table depends on the project, and I want to start following a standard/specification for these tables.
I believe I do no find information because it is not a general practise...but can someone comment on this, please?

Do you normally follow a spec when addying tables, and if so, which one...or do you normally add the table based on need?
Thank you very much in advance