Hello! Can you please guide, from where could I get installation setup for SX Programmer Expert (D300 win) software - version 3.5.1.15? Through online search, I could only find version 3.6.5.19.
This is required for accessing Fuji Electric's Steam-Turbine-Generator control system, which is based on Fuji Micrex-SX SPH 300 series PLC. This controller is referred to as Turbine-Generator Regulator (TGR) and hosts application for electro-hydraulic governor (EHG) and automatic voltage regulator (AVR).
Any help will be much appreciated!
This is required for accessing Fuji Electric's Steam-Turbine-Generator control system, which is based on Fuji Micrex-SX SPH 300 series PLC. This controller is referred to as Turbine-Generator Regulator (TGR) and hosts application for electro-hydraulic governor (EHG) and automatic voltage regulator (AVR).
Any help will be much appreciated!
