I have pretty much determined how the enable and reset rungs work for the timer. However, on the logic printout there is what AB would call an OTE instruction following the timer. Is this output equivalent to the enable bit, timer-timing bit, or the done bit?

 

It is very simple the first input is start/stop timing. The second input is reset/enable (enabled when on) and the output is just like a relay output i.e. when the timer reaches preset time it turns on the output and thus the coil connected to it. You can add a relay before the actual output if you like.

 

It is a very simple setup. The first input is start/stop timing. The second input is reset/enable, enabled when on. The output is just like a relay output you put a coil e.g. CR1 and when the timer times out it will turn CR1 on.