Hi all,
I am looking for a bit of advice if possible.
I am redesigning a machine I used to produce several years ago. Back then, the control system used the Beckhoff KL2552 (5v) motor drive modules. The (5v) refers to the sensor voltage.
The new system is going to use an EL7342 modules. The sensor voltage output is 24v..... My encoders are 5v.
As we are in the inter Christmas period, I cannot get hold of Beckhoff, so was just wondering if anyone knows if the EL7342 is available with a 5v sensor output (Cannot find one on their website, but then again, I cannot find the KL2552 (5v))?
If not, can I ask how everyone else would deal with this? a separate 5v power supply with the grounds commoned?
Potential Divider?
little 'buck' style DC-DC converter in the sensor supply output?
Thank You for any comments.
I am looking for a bit of advice if possible.
I am redesigning a machine I used to produce several years ago. Back then, the control system used the Beckhoff KL2552 (5v) motor drive modules. The (5v) refers to the sensor voltage.
The new system is going to use an EL7342 modules. The sensor voltage output is 24v..... My encoders are 5v.
As we are in the inter Christmas period, I cannot get hold of Beckhoff, so was just wondering if anyone knows if the EL7342 is available with a 5v sensor output (Cannot find one on their website, but then again, I cannot find the KL2552 (5v))?
If not, can I ask how everyone else would deal with this? a separate 5v power supply with the grounds commoned?
Potential Divider?
little 'buck' style DC-DC converter in the sensor supply output?
Thank You for any comments.