Control

Using PME 9.0 with GE Fanuc 90/30

S

Thread Starter

soversen

I am trying to build a project in PME 9.0 for a 9030 PLC. When I attempt to choose my rack (IC693CHS391L), the only options are IC695CHS007 012, 016. I believe these are RX3i racks. Am I mistaken in my assumption that I would be able to use PME for a 9030? Is there a setting in PME where I have to tell it to show me hardware for a 9030?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
B Honeywell PHD RDI connection to ControlLogix's PLC's using factory Talk SE Programmable Logic Controller - PLC 0
K Using peak load to minimise emissions in normal ops (Frame 6s / Mark VI) Power Generation 3
LamijaZ Communication between ABB RTU530 and Siemens 7SJ62 using IEC 60870-5-103 protocol General Automation Chat 0
ducanhasd Control Servo mitsubishi using FB Motion Control 0
G Retrieve engine data via ComAp using Modbus RTU General Communications Chat 0
Similar threads
Honeywell PHD RDI connection to ControlLogix's PLC's using factory Talk SE
Using peak load to minimise emissions in normal ops (Frame 6s / Mark VI)
Communication between ABB RTU530 and Siemens 7SJ62 using IEC 60870-5-103 protocol
Control Servo mitsubishi using FB
Retrieve engine data via ComAp using Modbus RTU

You May Also Like

Top