Facebook
Google
GitHub
Linkedin
Hello everyone,
I am currently facing an issue with two spare units (the last two we have available). As soon as the processor starts to boot, it immediately reboots and continues in a loop.
When attempting to start in DIAG mode, the unit shows a D0 error. According to the manual, this indicates that the module should be replaced.
Has anyone experienced a similar issue before?
Also, this may be a long shot, but does anyone happen to have a spare PM634 available for sale?
Kind regards,
I am currently facing an issue with two spare units (the last two we have available). As soon as the processor starts to boot, it immediately reboots and continues in a loop.
When attempting to start in DIAG mode, the unit shows a D0 error. According to the manual, this indicates that the module should be replaced.
Has anyone experienced a similar issue before?
Also, this may be a long shot, but does anyone happen to have a spare PM634 available for sale?
Kind regards,
