Configuration of KepserverEX to communication ControlWaveMicro through BSAP/IP

Hi Everyone,

I work in KepserverEX 6.4 to communication with ControlWaveMicro for BSAP/IP.

I followed the instructions of configuration in Kepserver and I call signal SECVLV1.PRESS1, but I get this message ""The response received from device is malformed.

I only have this data of ControlWave: IP, UDP and Local Adress.

Has anyone worked with BSAP / IP on Kepserver?
 
Hi Everyone,

I work in KepserverEX 6.4 to communication with ControlWaveMicro for BSAP/IP.

I followed the instructions of configuration in Kepserver and I call signal SECVLV1.PRESS1, but I get this message ""The response received from device is malformed.

I only have this data of ControlWave: IP, UDP and Local Adress.

Has anyone worked with BSAP / IP on Kepserver?
Hi Jar1984,

I dont know if you have read BRistol BSAP /IP drive manual??

Well the error message that you pointed is listed on this manual .

Please have a look at pages 26/27 of the attached manual.

According to manual there should be unreliable communication between driver and device .

Let us know what you think about that document.

Regards,
Controls Guy25.
 

Attachments

Hi Jar1984,

I dont know if you have read BRistol BSAP /IP drive manual??

Well the error message that you pointed is listed on this manual .

Please have a look at pages 26/27 of the attached manual.

According to manual there should be unreliable communication between driver and device .

Let us know what you think about that document.

Regards,
Controls Guy25.

Hi ControlsGuy25,

Thank you for you Answer.

I read the handbook "Bristol/IP Driver" before I try in the Kepserver. On the other hand, the comunication of RTU's is to 2 way: VSAP and other UHF. In the test with kepserver I saw that communication statistics of one RTU specifically port ETH1 it become slow, when finally test ETH1 quickly communicate back to SCADA. In the before test kepserver show me the menssage "The response received from device is malformed". The RTU in test have communication VSAP.

Has anyone worked with BSAP / IP on Kepserver?
 
Top