Connecting Diesel Engine ECU To PLC


Thread Starter


I need technical guidance to connect new diesel engine (volvo penta TAD 1641 g) ECU (model EMS2) which is transferring data through CAN BUS standard J1939 to rubber tired gantry crane control software which is Siemens step 7 series 200.

There should be an interface module (whatsoever called : converter , inverter ....) made by Siemens company as all electronic component and boards are made by Siemens

I need to get all engine data while is running in 4 positions including 2 HMI in operator cabin and electrical room.

my e-mail address is as follow :
[email protected]

your prompt reply is highly appreciated in advance