G
I have an issue which i can't understand please help me in this regards which is assignments of pressure transmitters (CPD) in Mark V (TMR) control system. I had viewed IO.ASG file in which i have found only one pressure transmitter assigned on <R> TBQB(Q_R_CPD CPD PRESS ;Q -TBQB-003 Compressor discharge press transmitter). but as per hard wiring & TC2KERPT, I have 3-Transmitters connected as below (<R>TBQB 001/003 CPDRPP/CPDRP 96CD-1)(<R>TBQB 005/007 CPDSPP/CPDSP 96CD-1B)(<R> TBQB 009/011 CPDTPP/CPDTP 96CD-1C).
I am unable to find it out where & how these remaining two transmitters are assigned. Because as per my knowledge, all MARK V Hardware IO (switches T/C, Transmitters etc.) should be in IO.ASG. I am unable to find out these individuals transmitters in CSP.PRN.
One more issue that is same like above is with Flame Scanners. I have 4-flame scanners installed on GT, but it is also not assigned in IO.ASG.
Please reply me that how these Pressure TX' & Flame Scanners are assigned & how can I see these 3-transmitters’s reading online. How i can generate TC2KERPT.
Thanks
REHAAN
I am unable to find it out where & how these remaining two transmitters are assigned. Because as per my knowledge, all MARK V Hardware IO (switches T/C, Transmitters etc.) should be in IO.ASG. I am unable to find out these individuals transmitters in CSP.PRN.
One more issue that is same like above is with Flame Scanners. I have 4-flame scanners installed on GT, but it is also not assigned in IO.ASG.
Please reply me that how these Pressure TX' & Flame Scanners are assigned & how can I see these 3-transmitters’s reading online. How i can generate TC2KERPT.
Thanks
REHAAN