DNP 3 implementation on GE Fanuc PLCs


Thread Starter

CS Nagaraj

We are looking for standard implementation of DNP 3 (slave) protocol in PCM module of GE-Fanuc 90-70 PLCs. Can we get a good reference which is immediately available as commerically off the shelf product. The protocol driver shall take care of total I/O of about 1024 or even higher.

Prasanth Gopalakrishnan

u might want to check "": who have off-the shelf DNP3 Level 1/2 support products available for both 90-30 and 90-70 series PCM's.

Prasanth Gopalakrishnan
Managing Director
Kalki Communication Technologies Private Limited,
2nd Floor, #147, 5th Main Road, HSR Sector 7
Bangalore 560034, Karnataka, India
Phone(O): 91-80-572 1263/4
Phone(H): 91-80-572 0353
Fax: 91-80-5721264, 1 646 365 7718
E-mail: [email protected]

William Klinton

We have used many of Control Protocols International's products with excellent results. They have been responsive to questions and very helpful with initial setups. They are the only ones I know of who have a DNP option for the GE Fanuc PLC's.