Failure to break shaft away

Please I will need your advise on how to solve this failure to enter cooldown/TG STARTING MEANS TURB SHFT FAIL TO BREAK TURB AWAY...{G3\ L48CR_ALM}
 
What is frame of the unit ( Frame 9E ..,?)

Check equipment, which is the cause of the problem in the normal sequence: starting system power, torque converter, fuel control, and acceleration loop.

Check if the AUTO order has been executed.

L48CR_ALM TURBINE SHAFT FAILURE TO BREAK AWAY

The time delay is finished and the turbine shaft does not breakaway.

Check operation of the lifting/jacking oil pump .... if it is a Frame 9..

James

Starting means fault.

Check the operation of the auxiliaries.

Check the starting means.
 
What is frame of the unit ( Frame 9E ..,?)

Check equipment, which is the cause of the problem in the normal sequence: starting system power, torque converter, fuel control, and acceleration loop.

Check if the AUTO order has been executed.

L48CR_ALM TURBINE SHAFT FAILURE TO BREAK AWAY

The time delay is finished and the turbine shaft does not breakaway.

Check operation of the lifting/jacking oil pump .... if it is a Frame 9..

James

Starting means fault.

Check the operation of the auxiliaries.

Check the starting means.
Yes it's a Frame 9E Turbine
 
Top