Control.com

GE-Fanuc 90-30 (CPU363)

Search Forums New Posts
A

Thread Starter

Anonymous

Can Anybody guide on the following?

What is the procedure/ Configuration set-up for the GE-Fanuc 90-30 (CPU363) PLC time synchronisation with the SCADA Server?

The PLC has Ethernet(TCP/IP) Communication with SCADA server.
 
J

Jairo

In our system we use a synchronitation bit using the %S register to setup the clock at 00:00, this bit is send by the SCADA server using a scheduled task.

This in case you ethernet card does not suport SNTP protocol.

regards,
Jairo
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
K FANUC 3 point TCP SET Robotics 0
S Matrikon OPC support Fanuc CNCs supports communications with multiple protocol networks, including Fanuc Focas 1 Ethernet and Fanuc Focas HSSB Open Platform Communications (OPC) 0
S Using PME 9.0 with GE Fanuc 90/30 Programmable Logic Controller - PLC 1
AxonControlEngineering ABB Infi90 DCS and GE Fanuc Rx7i hand-on experienced Freelancer is needed for a quick engagement General Automation Chat 0
X GE Fanuc Series 90-30 PLC using Proficy Machine Edition General Automation Chat 2
Similar threads
FANUC 3 point TCP SET
Matrikon OPC support Fanuc CNCs supports communications with multiple protocol networks, including Fanuc Focas 1 Ethernet and Fanuc Focas HSSB
Using PME 9.0 with GE Fanuc 90/30
ABB Infi90 DCS and GE Fanuc Rx7i hand-on experienced Freelancer is needed for a quick engagement
GE Fanuc Series 90-30 PLC using Proficy Machine Edition

You May Also Like

Top