Hi,
I have a CDC007-2 drive amplifier (actually a complete drive controller with 5.7kVA three phase output stage and quite some computing power inside) here that refuses to get "ready" - the green LED #1 remains off. No error is indicated on the yellow LEDs, but internally is a "traffic light" of three SMD LEDs, the red one is flashing, the yellow one steady on, the green one off. The fan of the unit has failed, but as far as I can see it is not monitored (no tacho line and it seems to be directly connected to internal +24V with no sense resistor etc in between). I wonder if I could see more with the VecWin software - at least when we decide to get a used, tested CDC007 to get the machine up again I'll need it anyway to copy the configuration.
So, does anyone have a) the VecWin software and b) experience with the fault described?
Thanks
Stefan
I have a CDC007-2 drive amplifier (actually a complete drive controller with 5.7kVA three phase output stage and quite some computing power inside) here that refuses to get "ready" - the green LED #1 remains off. No error is indicated on the yellow LEDs, but internally is a "traffic light" of three SMD LEDs, the red one is flashing, the yellow one steady on, the green one off. The fan of the unit has failed, but as far as I can see it is not monitored (no tacho line and it seems to be directly connected to internal +24V with no sense resistor etc in between). I wonder if I could see more with the VecWin software - at least when we decide to get a used, tested CDC007 to get the machine up again I'll need it anyway to copy the configuration.
So, does anyone have a) the VecWin software and b) experience with the fault described?
Thanks
Stefan