Hi,
Could anyone please inform how to move the Analog input signals DWATT and DVAR to Analog output signals DWATT_OP and DVAR_OP without doing some modifications in the Big Block present in the Mark V logic?

Regards,
Has100

 

Has100,

MAOUT_Q.SRC is used to assign and scale existing signals (like DWATT & DVAR) to analog outputs of <C> (on CTBA terminal board). No changes/modifications to the CSP (Control Sequence Program) necessary. There are details for the scaling in the comments at the top of the file.

What's not clear from your post is where the signals DWATT_OP & DVAR_OP originate--unless this is what you want the names to be.

Hope this helps!