D
I tried to connect two PLC-s using PROFIBUS ILM module. One switchboard is fixed and second one is rotating. My problem is that on some angle network error occurs. Any ideas how to configure this network without errors?
Thread starter | Similar threads | Forum | Replies | Date |
---|---|---|---|---|
D | When to use profibus over Fieldbus | Modbus | 3 | |
T | Profibus Pa Configuration | Instrumentation & Measurement | 4 | |
O | Regarding Applicom Profibus and FMS protocol . | Human Machine Interface - HMI | 1 | |
S | Profibus | General Automation Chat | 0 | |
G | Profibus Comm Between S7 300 and Emerson Delta V Controller | Networking | 6 |