Rosemount Level Communication with Emerson 475 Communicator using Fieldbus

G

Thread Starter

gajoshi17

Hi Guys,

Did anyone performed the process value simulation of Rosemount 5300 Level Transmitter (FF Communication) using Emerson 475 communicator? The simulation jumper is not available physically on the device. The only simulation option in the hand held communicator available in the following path.

Configure>>Manual Setup>>Classic View>>Advanced Transducer Block>>Parameters1

But that option too is highlighted and not editable. Can anybody help me how to simulate the value from device so that I can check in my host DCS (Siemens PCS7).

Thanks in Advance,
GJ
 
Top