Hi

Please any one help me to find a Rotork circuit diagram num 100B0300-4 of Rotork valve type IQ35

Regards
Laid86

 

Hi

I got the mentionned circuit diagram but issue number 5

Are you looking for the circuit diagram 100BO300 issue number 4??

Do the Valve is equipped with Pakscan +IQ...

Regards,
James

 

Hi,
Yes I'm looking for the wire diagram number 4, but it will be helpful for me to get number 5, I will appreciate to send it to me.
Regards
Laid86

 

Hi

You did not reply on Pakscan and IQ for this Rotork Device

 

Hello,

Pakscan is a remote control form, in network option,
In our valve just we use 2 wires for the remote mode (0 or 24VDC),
I didn't understand what do you mean the valve equipped by IQ?

Salutation
Laid86

 

Again,

I have problem of remote control, the valve didn't respond in remote mode,
The valve is a new one, when I demand a circuit diagram, I suspected to montage is not correct,
All the parameters shows that it is good, but the valve does not work in remotely mode

Regards
Laid86

 

Hello,

IQ mean that kind of Intelligent Valve device from Rotork...it got some features/options ..you can check on the web for more details.

Regards,
Jamal

 

On the circuit diagram that i got it is well shown the +125VDC remote module control wiring

 

Are you sure about the +24VDC remote control voltage as i see that is for the control command of the Valve motor

Rotork drawing show +125VDC for remote module control

 

Hi again,

Yes, the valve is equipped with IQ

Laid86

 

I'm didn't sure for anything, the only one I'm sure for it is the local configuration, it is set as well and the valve works properly in local mode

Laid86

 

Jamal

For the diagram which you have, can you send it to me.

Laid86

 

Local mode should use +24VDC as per drawing

Remote mode is about +125VDC as per drawing

 

Jamal

For the diagram which you have, can you send it to me.

Laid86

Laid86,

Read Private message i wrote to you in conversation ...

The diagram i got is 100BO300 issue number 5

 

Excuse me, where can I find it

Laid86

 

Laid

Click on the icon "bubble" " bulle " in french above to the thread at the welcome page of the forum

It is located near the Icon "Bell" when you see message are coming...it is so simple to get access..

Jamal

 

Jamal , I found your message you can check it again

Thanks
Laid