B
I want time to update 10 holding register and 10 coil register at master side. If my slaves are connected by RS 485 in daisy chain and Baud rate: 9600, data bit: 8, stop bit: 1, parity: Even.
I am reading those data in SCADA.
Then how to calculate time to update all data?
Is it affect Time out of device and/or response time of devices?
What other parameter are required to calculate those time?
I'm using one converter to convert Modbus RTU to Modbus TCP, and in SCADA data scanned by 100Mbps Ethernet speed.
I am reading those data in SCADA.
Then how to calculate time to update all data?
Is it affect Time out of device and/or response time of devices?
What other parameter are required to calculate those time?
I'm using one converter to convert Modbus RTU to Modbus TCP, and in SCADA data scanned by 100Mbps Ethernet speed.