Working on a shrink wrap program using a
"AB SLC500/03"CPU and an
AB Panelview Plus600 HMI.
I have a logic sequence that is true, but the Binary OTE will NOT change state. No duplicate rung using the same bit address can be found. Installed a jumper in logic around all instructions,and Binary output will not turn on. Any suggestions ??
"AB SLC500/03"CPU and an
AB Panelview Plus600 HMI.
I have a logic sequence that is true, but the Binary OTE will NOT change state. No duplicate rung using the same bit address can be found. Installed a jumper in logic around all instructions,and Binary output will not turn on. Any suggestions ??